Versions with front wheel drive only (2WD):
1. Bracket plate.
2. Front subframe with #1 engine mount pad.
3. Engine mount bracket #1.
4. Engine mount bracket #4.
5. Motor mount #3.
6. Power unit assembly.
Versions with all-wheel drive (4WD):
1. Bracket plate.
2. Front subframe with #1 engine mount pad.
3. Engine mount bracket #4.
4. Mounting support No. 3 of the engine.
5. Power unit assembly.
Attention.
- Hot engine and oil can cause burns. Be careful not to burn yourself when removing/installing various components.
- Fuel vapors are dangerous. They are highly flammable, causing serious injury and equipment damage. Keep sparks or open flames away from fuel.
- Secure the steering wheel with electrical tape or wire to prevent the steering shaft from turning after it has been released. If the steering wheel is rotated after the steering shaft is disconnected from the steering gear, the internal parts of the contact disk may be damaged.
Note:
- The engine is removed from the vehicle complete with gearbox.
- Removal / installation of the power unit (engine with gearbox assembly) produced from below the vehicle.