2. Disconnect the negative cable from the battery.
Type - headlamp
Location of headlight parts - lamp-headlight type
1. Upper grille cover; 2. Radiator grille; 3. Headlight holder and skeb combination; 4. High beam adjustment screw; 5. Spring; 6. High beam headlight assembly; 7. Screw for adjusting the dipped beam; 8. Spring low beam; 9. Headlight low beam assembly; 10. Headlight illumination assembly; 11. Suspension
3. Remove the headlight holder and headlight assembly.
4. Remove the four screws that secure the retaining ring and remove the ring. Hold the headlight bulb assembly as done, unplug the connector and remove it from the vehicle (photo).
Hold the headlight while disconnecting the connector
5. Install the new unit firmly enough to attach the wires, retaining ring, and mounting screws.
6. Install the holder and check its proper operation. If the adjusting screws have not been turned, the headlamp should not require adjustment.
Type - with incandescent lamp
Details of installation of a headlight with an incandescent lamp
1. Radiator grille; 2. Headlight illumination assembly; 3. Bolt; 4. Internal spring; 5. External spring; 6. Headlight adjustment screw; 7. Foundation; 8. Bolts; 9. Suspension; 10. Headlight assembly (cover, spring, diffuser, bulb and holder)
7. Remove the front sidelight assembly.
8. Remove the bolts and release the springs that secure the headlight assembly. Disconnect the bulb harness connector and remove the headlight assembly from the suspension.
9. For bulb replacement, see Chapter 10.
10. Assembly is carried out in the reverse order.