Oil pump installation details
1. Asterisk; 2. Pallet; 3. Oil sensor strainer
Removing
1. Remove the toothed drive belt covers, toothed drive belt and crankshaft sprocket.
2. Remove the pallet.
3. Remove the cover bolts of the front engine mount plate.
4. Unscrew and remove the transfer tube assembly.
5. Insert a screwdriver into the corner of the cover to break the gasket and remove the cover.
6. Clean the oil pump contact surfaces to remove the old gasket material.
Installation
7. Coat the O-ring with petroleum jelly and insert into the pump. Seal the pump casing as shown in the accompanying illustration. Coat the oil seal boss with clean engine oil.
Seal the dark areas of the oil pump housing
8. Place pump and new gasket and install bolts. Tighten the bolts with the tightening force specified in the Specifications.
9. Using a new gasket, install the transfer tube. Tighten the bolts with a torque specified specifications.
10. Install the pallet.
11. Install new oil filter and replace oil pressure sensor harness (if deleted).
12. Install the engine mount plate and tighten the bolts.
13. Install the toothed drive belt, covers and crankshaft sprocket.