Oil pump
Previous the gap between the teeth of the outer pole. and crescent - 0.33 mm
Before, the gap between the teeth of the inner pole, and the crescent - 0.41 mm
The clearance between the outer gear and the pump housing is 0.20 mm
Gap between gear and pump cover - 0.10 mm
Tightening torques, Nm
Bolt of fastening of a suspension bracket of the generator to the engine — 37-63
Alternator adjusting bolt - 19-35
Bolts of fastening of a head of the block of cylinders
- Warm engine - 95-110
- Engine cold - 82-88
Camshaft sprocket bolt - 48-66
Rocker arm axle bolts - 18-28
Camshaft cover bolts - 2.8-4.1
crankshaft pulley bolts
- 1.6 l - 8-12
- 2.0 l - 11-16
Exhaust manifold bolts/nuts - 22-29
Engine mount bolts:
- Pillow of fastening of the engine No. 1 to transmission — 37-52
- Pillow of fastening of the engine No. 1 to a body — 44-55
- Pillow of fastening of the engine No. 2 to transmission — 37-52
- Pillow of fastening of the engine No. 2 to a body — 44-55
- Pillow of fastening of the engine No. 3 to a body — 44-55
- Pillow of fastening of the engine No. 3 to the engine — 57-81
Flywheel/drive plate bolts - 98-105
Intake manifold bolts/nuts - 19-26
The central nut of the oil cooler - 30-40
Oil pan bolts - 7-12
Bolts of a flange of a reception tube of the oil pump — 8-12
Oil pressure sensor - 12-18
Bolts of fastening of the oil pump to the block — 19-26
Nuts and bolts of the rear cover of the gearbox - 19-26
Bolt of an asterisk of a gear drive belt — 110-120
Stop, mechanical bolt. toothed drive belt tension - 38-53
Water bypass hose clamp - 19-35
Bolt inlet pipe assembly to the water pump - 19-26
Bolt suspension of the water inlet pipe to the engine - 39-52