Car steering Mazda 626 (3 and 4)

General information about steering
Pic. 11.14. Steering: 1 – sound signal button; 2, 11, 12 - nuts; 3 – a steering wheel; 4 – combination switch; 5 – a casing of a steering column; 6 - screw; 7 - bottom...

Steering wheel — removal and installation
To remove and install, follow the steps below. Disconnect the wire from the negative battery terminal. Remove the horn button, trim plate and disconnect the connector...

Steering column — removal and installation
Follow the steps below to remove and install. Disconnect the wire from the negative battery terminal. Remove the steering wheel. Remove the steering column cover and...

Tie rod end — removal and installation
To remove and install, follow the steps below. Raise the front of the vehicle and secure it on stands. Remove the front wheel. Pic. 11.15. Tie rod end and steering gear...

Steering gear protective cover
The protective cover of the steering mechanism provides protection of details from dirt and water. It must be periodically checked for holes, cracks and other damage, as...

Removal and installation of the steering mechanism
Remove the pinch bolt that secures the intermediate shaft to the steering rack gear. Raise the front of the vehicle, secure it on stands and remove both front wheels....

Power steering pump
Disconnect the wire from the negative battery terminal. Raise the front of the vehicle, secure it on stands and remove the right front wheel and mudguard. Pic. 11.22....

Removing air from the hydraulic drive of the power steering
After any operation that disconnected the power steering lines, the power steering system must be bled of air. Raise the front of the vehicle and secure it on stands....

Power Steering Valve Adjustment (since 1984)
Connect a tachometer to the engine, then start and warm up the engine to normal operating temperature. Disconnect the connector from the power steering valve. Pic....