Removing
Raise the front of the car and place on stands.
Remove the front right wheel and mudguard.
Loosen the drive belt and remove it from the pulleys.
Loosen the drive belt pulley bolts.
Insert a large screwdriver into the technological window in the clutch housing and insert it between the teeth of the flywheel crown, thereby blocking the crankshaft from turning.
Having asked an assistant to hold the screwdriver, unscrew the bolt securing the crankshaft pulley, remove the bolt and washer.
Remove the pulley.
Installation
Install the pulley and mounting bolts, hand-tighten the drive pulley mounting bolts.
Having fixed the crankshaft from turning, tighten the bolts securing the drive belt pulley to the required torque.
Install and tension the accessory drive belt.
Install the mudguard, wheel and lower the car.