Manual gearbox Mazda 626 (3 and 4)

General information about manual transmission
The gearbox converts the torque transmitted from the engine in magnitude and direction. This is necessary to ensure optimal speed, high cross-country ability of the...

Technical data for manual transmission
Technical data Tightening torques, Nm Front nuts and rear cross member mounting bolts - 44–55 Back bolts of fastening of a back cross member — 95–118 Lower ball joint...

Gearbox Mounts — Check and Replace
Examination Observe the gearbox mounts as the assistant lifts and pushes down on the gearbox. If the mount rubber separates from the steel base or the transmission case...

Gear shift lever — removal and installation
Removing Pic. 9.12. Elements of the gear lever: 1 – the handle of the gear lever; 2 - cover; 3 - details of the switching lever; 4 - spring; 5 - upper ball seat; 6 -...

Removal and installation of a transmission
Removing Disconnect the wire from the negative battery terminal. Disconnect the speedometer cable from the transmission, the connector from the reverse light switch and,...

Gearbox disassembly
Pic. 9.17. The main elements of the gearbox: 1 - main gear and differential; 2 – knot of the cranked lever; 3 - steel ball; 4 - spring; 5 – magnet; 6 - locking bolt; 7 -...

Gearbox Assembly
Screw the drain plug into the gearbox housing. Install the output shaft bearing outer race, aligning it correctly with the shims. Use a hammer and drift to lightly tap...

Replacing gearbox seals
The input shaft seal can only be replaced after the gearbox has been removed. The drive shaft seals can be replaced with the gearbox installed. Replace as follows....