Electrical equipment of the car engine Mazda 626 (5)

Elements of battery recharging and ignition systems
Models with 4-cylinder engine 1. Fuse box / relay; 2. Battery; 3. Ignition distributor; 4. Generator Models with 6-cylinder engine 1. Fuse box / relay; 2. Battery; 3....

Specifications
Battery voltage Engine off 11.5 - 12 Volts engine running 13.5 - 15 Volts Ignition system System type 1993 Ignition distributor, integrated ignition coil and electronic...

Battery — Check and Replace
Examination 1. Disconnect the negative battery cable and then the positive battery cable. 2. Check the charge level of the battery. 3. Check that when a load is applied...

Ignition system — check
The ignition system provides full control over the adjustment of the ignition timing. The electronic control unit determines the optimum ignition timing for a given...

Ignition coil — check and replacement
Examination Ignition systems with ignition distributor 1. Check that the ignition is off. 2. Disconnect the ignition coil connector and check the resistance of the...

Electronic control unit of the ignition system
It is possible to check the health of the electronic control unit only by the exception method, or by contacting specialists, since there are no special tests designed...

Ignition distributor — removal and installation
Removing 1. Disconnect the negative battery cable. 2. Disconnect the wires from the ignition distributor. 3. Remove the distributor cap and turn the engine crankshaft so...

Battery Charging System — Check
The battery recharging system includes a generator, a voltage regulator, a battery charging signal light, a battery, a burnable jumper and connecting wires. When working...

Generator — removal and installation
Removing 1. Disconnect the negative battery cable. 2. Disconnect the connector and wire "masses" from the generator. Models with a four-cylinder engine 3. Remove the...

Starter and engine starting system
The engine start system consists of a battery, a starter, a solenoid relay and connecting wires. The solenoid relay is located on the starter. When working on the engine...

Starter solenoid relay — removal and installation
Removing 1. Disconnect the negative battery cable. 2. Remove the starter. 3. Disconnect the thick wire connecting the relay and starter. Loosen the fixing screws...