Attention! During the test, the engine must be slightly raised to transfer its weight from the supports to the hoist.
Right engine mount
1. Support through bolt
2. Dynamic support damper
3. Support bracket nuts
Examination
1. Check rubber mounts for cracks and damage.
2. Move the supports with a large screwdriver, if the supports are loose, tighten their fasteners.
Replacement
Supports (N1 and N2) engine and gearbox
1. Unscrew the nuts of the support securing it to the cross member.
2. Unscrew the through bolts and remove the support from the bracket.
3. Remove the cross member bolts and remove the cross member.
4. Install the new support on the bracket and tighten the bolts.
Right support (N3) engine
5. Unscrew and remove the through bolt of the support.
6. Remove the dynamic damper from the support.
7. Unscrew the support bracket nuts and remove the support.
8. Install a new support, insert and tighten the bolt and nuts.
Left support (N4) engine
9. Remove the battery and battery mount.
10. Unscrew the bolts and nuts of the support bracket.
11. Unscrew the support bolts.
12. Remove the support.
13. Install a new support.