Removing
1. Disconnect the negative battery cable.
2. Raise and secure the front of the vehicle.
3. Remove the bottom engine cover.
4. Drain the engine oil and remove the oil filter.
5. Remove the dipstick to measure the oil level.
6. Disconnect the wire from the oxygen sensor. Disconnect the exhaust pipe from the exhaust manifold and lower the pipe along with the catalytic converter.
7. Unscrew the bolts and remove the oil pan.
Installation
1. Thoroughly clean and wipe the mating surfaces of the sump and cylinder block with a solvent or acetone.
2. Clean the bolt holes in the cylinder block.
3. Inspect the oil pan for cracks or other damage.
4. Apply sealant to the oil pan flange.
5. Install the pallet and tighten the bolts.
6. Install the remaining parts, start the engine and check the oil pan for leaks.