2. Install the top compression ring into the cylinder using the piston.
3. Measure the ring end clearance. If the gap is too small, you can replace the piston rings or increase the gap by turning the ends of the piston ring with a fine file.
4. Do the same for all rings.
5. After checking and adjusting the end clearance, the rings can be installed on the pistons.
 |  |
6. The oil scraper ring is installed first. First install the expansion ring in the groove, then install the lower and upper oil scraper rings.
7. After installing all the elements of the oil scraper ring, check that the upper and lower rings rotate freely.
8. Install the second compression ring with the special tool with the mark up.
9. Then install the top compression ring.
10. Do the same for the remaining pistons.