Note. The models described in this manual are equipped with an airbag system. Before working in close proximity to shock sensors, steering column or front panel, disconnect the wire from the negative battery terminal, then the wire from the positive battery terminal, then wait at least 3 minutes. Accidental airbag deployment can cause injury (see chapter 12). The airbag wiring harness through the dash and center console is yellow. Do not connect a tester or car system wires to these wires.
Warning. If the car radio installed in your car has an anti-theft code, make sure you have the code to unlock it before disconnecting the battery.
1. On models with an adjustable steering column, lower the column as far down as possible.
2. Remove the screws, separate the trim halves and remove them from the vehicle (pic. 29.2).
3. Installation is done in sequence. reverse withdrawal.