Remove the rack cover clamp.
Adjust wheel alignment by turning both tie rods (left and right) in opposite directions by the same amount.
Note. For one turn of the tie rod of one wheel, the toe angle changes by approximately 6 mm.
Note. Each tie rod has a right hand thread.
To increase the toe angle, rotate the right tie rod toward the front of the vehicle and the left tie rod toward the rear of the vehicle by the same amount.
Tighten the tie rod end locknut.
Tightening torque: 68.6 - 98.0 Nm.
Make sure the rack cover is not twisted and install the rack cover clamp.