Vehicle lighting system Mazda 3 (BK)

Location of outdoor lighting devices
Pic. 7.12. Location of outdoor lighting devices in vehicles with bodies «sedan»: 1 - high beam headlights; 2 - front marker lights; 3 - low beam headlight; 4 - upper...

Front combination lamp
Pic. 7.14. Front combination lamp: 1 - headlight lamp (dipped beam); 2 – a lamp of a gas-discharge headlight (dipped beam); 3 – a lamp of the forward indicator of turn;...

Discharge headlight — description
Compared to modern headlights, the area of illumination is increased. In addition, white light, close in spectrum to sunlight, provides better visibility when driving at...

The design and operation of a gas discharge headlight
high voltage pulse (alternating current with a voltage of approximately 25,000 V) from the control unit of a gas-discharge headlight is fed between the terminals of its...

Headlight fault detection function
Input voltage drop detection function If the input voltage of the gas discharge headlight control unit (9-16 V) less than normal (except for the voltage drop immediately...

Headlight leveling system
Headlight leveling system (pic. 7.17) Pic. 7.17. Headlight auto leveling system: 1 - automatic leveling control unit (main); 2 - automatic leveling control unit...

Driving light control system
Pic. 7.20. Scheme of the lighting control system when driving a car: 1 - lighting control unit when driving; 2 – relay A; 3 - relay B; 4 - headlight relay; 5 - headlight...

Rear combination lamp and interior combination lamp
A stepped reflector is used to diffuse and reflect the light from the rear combination and interior combination lamps. A flat, uncut lens is used to control the...

Removal and installation of the forward combined headlight
Warning! Improper maintenance of gas discharge headlights can result in electric shock. Note. When the ignition switch is turned to the ON position, the sound of the...

Headlight adjustment
Low beam adjustment Pic. 7.22. Scheme for adjusting the dipped beam headlights Install the headlight adjustment screen as shown in Figure 7.22. Bring the air pressure in...

Removal and installation of a lamp of a headlight
Disconnect the negative cable from the battery. Disconnect the front combination headlight. Pic. 7.27. How to remove headlight components: 1 - cover; 2 - connector; 3 -...

Removal and installation of a gas-discharge lamp of a headlight
Warning! Improper maintenance of gas discharge headlights can result in electric shock. Disconnect the negative cable from the battery. Disconnect the front combination...

Removal and installation of a lamp of a parking lantern
Disconnect the negative cable from the battery. Disconnect the connector. Remove the bulb holder, then remove the parking light bulb (pic. 7.29). Pic. 7.29. Removing the...

Removal and installation of the forward indicator of turn
Disconnect the negative cable from the battery. Pic. 7.30. To remove the front turn signal lamp components: 1 - lamp holder; 2 - lamp Remove in the order shown in Figure...

Removal and installation of the lateral indicator of turn
Disconnect the negative cable from the battery. Pic. 7.31. To remove the side turn signal lamp components: 1 - front side turn indicator; 2 - connector Remove in the...

Front fog light adjustment
Bring the air pressure in the tires to normal. Place the unladen vehicle on a level surface. Place one person in the driver's seat. Place the car at a distance of 3 m...

Removal and installation of the rear combination lamp
Disconnect the negative cable from the battery. Remove the trunk side trim. Pic. 7.34. Rear combination lamp components: 1 - connector; 2 - bolt; 3 – the back combined...

Removal and installation of the internal combined lantern
Disconnect the negative cable from the battery. Remove the trunk lid trim (tailgate bottom trim). Pic. 7.35. Internal Combination Light Components: 1 - connector; 2 -...

Removal and installation of a lantern of illumination of license plate
Disconnect the negative cable from the battery. Pic. 7.38. Removing the license plate light Remove the lens, then remove the license plate light bulb (pic. 7.38). Remove...

Removing and installing an additional brake signal on the rear spoiler
Disconnect the negative cable from the battery. Remove the rear spoiler. Pic. 7.40. Filament Installation Diagram Tie a string to the end of the auxiliary brake light...

Removal and installation of a forward lantern of illumination of salon
Disconnect the negative cable from the battery. Pic. 7.42. Components of the front interior light: 1 - front lamp; 2 - connector; 3 - lamp holder; 4 - lantern lamp...

Removal and installation of the limit switch of a door
Front end Disconnect the negative cable from the battery. Pic. 7.45. To remove the door limit switch components: 1 - screw; 2 - door switch; 3 - connector Remove in the...

Removal and installation of a lamp of illumination of an ashtray
Disconnect the negative cable from the battery. Remove the cover panel. Pic. 7.48. To remove the ashtray lamp: 1 - lamp holder; 2 - ashtray lighting lamp Remove in the...

Removal and installation of a lamp of illumination of the lock of ignition
Disconnect the negative cable from the battery. Remove facing of a steering column. Pic. 7.49. Removing the ignition switch lamp Remove the ignition switch light (pic....

Removal and installation of a lamp of illumination of a ware box
Disconnect the negative cable from the battery. Pic. 7.50. How to remove the glove box light: 1 - lamp holder; 2 – a lamp of illumination of a ware box Remove in the...

Removal and installation of the operating switch of illumination on the panel of devices
Disconnect the negative cable from the battery. Pic. 7.51. To remove the lighting control switch on the instrument panel: 1 - control switch for lighting on the...

Mazda 3 exterior lighting system
Table 7.3. Mazda 3 exterior lighting system Table 7.4. The main characteristics of the lighting control system

Voltage at the terminals of the lighting control switch on the instrument panel
Table 7.8. Voltage at the terminals of the lighting control switch on the instrument panel

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

More sections on repairs of other Mazda models
• Electrical equipment: Lighting and headlights Mazda Familia 6 (1989-1994)
• Electrical equipment: Lighting and lamps Mazda Capella 3 (1982-1992, petrol)
• Electrical equipment: Lighting system Mazda6 GG (2002-2008)
• Electrical equipment: Lighting system Mazda 121 (3) (1996-2003)

Share with friends on social networks:

Link in different formats to this section

TEXTHTMLBB Code

Mazda3 BK (2003-2009)