Warm up the engine to normal operating temperature.
Stop the engine and wait 5 minutes.
Remove the dipstick to measure the oil level.
Pic. 2.288. Checking the oil level on the dipstick
Check that the oil level is between the F and L marks on the dipstick and evaluate the condition of the engine oil. If the oil level is below the L mark, add oil (pic. 2.288).
Attention! If during the process of changing the oil some of it accidentally gets on the working parts of the engine, wipe it off as thoroughly as possible. Remaining oil that has not been wiped off can cause smoke in the engine compartment.
Remove the oil filler cap and drain plug from the oil pan and oil filter.
Drain the engine oil into a container.
Install the oil filter drain plug with a new O-ring.
Torque (oil filter drain plug): 9–10 Nm.
Clean the flange of the oil pan drain plug) and put the plug back in place.
Torque (oil pan drain plug): 25–30 Nm.
Refill the engine with the specified type and quantity of engine oil.