Pic. 2.86. Installing the special tool on the camshaft
Install the special tool on the camshaft (see fig. 2.86).
Pic. 2.113. Crankshaft pulley lock bolt: 1 - bolt
Install the M6x1.0 locking bolt and tighten it by hand (pic. 2.113).
Turn the crankshaft clockwise to TDC on cylinder #1.
Pic. 2.104. Installing the special tool on the crankshaft: 1 - special tool
Hold the crankshaft pulley with a special tool (see fig. 2.104).
Tighten the crankshaft pulley mounting bolt in two steps:
- tighten the bolt to a torque of 96–104 Nm;
- tighten bolt 87–93°
Loosen the M6x1.0 bolt.
Remove the special tool from the camshaft.
Remove the special tool from the hole in the bottom plug of the cylinder block.
Turn the crankshaft clockwise two turns to TDC on cylinder #1. If the TDC position cannot be reached, loosen the crankshaft pulley mounting bolt and repeat the above steps from the beginning.
Establish the bottom plug of the block of cylinders and tighten it with the moment of an inhaling of 18–22 Н·м.