Disconnect the front disc brake caliper.
Pic. 3.117. Removing the brake disc
Remove the brake disc (pic. 3.117).
Pic. 3.118. Checking the clearance in the rear wheel bearing
Install dial gauge against wheel hub (pic. 3.118).
By moving the wheel hub manually in the axial direction, measure the clearance in the hub bearing.
Maximum: 0.05 mm.
If the clearance exceeds the maximum, replace the bearing.
Attention! Performing the following procedures without first removing the Anti-Lock Braking System Wheel Speed Sensor may cause an open circuit in the wiring harness if the harness is taut by mistake. Before performing the following operations, remove the anti-lock brake wheel speed sensor (from the side of the body) and mount it in a suitable location where the sensor will not be damaged by mistake when performing maintenance.