Car doors and windows Mazda 6 (GG)

Front and rear door components
The internal structure of the door includes: a power window regulator, an internal handle, a door speaker, a harness, and internal baffles. The wavy shaped side impact...

Removal and installation of a forward door
Disconnect the negative battery cable. To remove the front door hinge, remove the front fender panel. To remove the door stop, remove the door speaker. Pic. 8.18....

Removal and installation of a back door
Attention! Improper handling of the side airbag sensor may result in accidental deployment of the airbag, which may result in serious injury. Note. The side airbag...

Removal and installation of glass of a forward door
Pic. 8.21. Glass installation before removal Install the front door glass so that the distance from the top of the front door glass to the window trim is 210mm (pic....

Removal and installation of glass of a back door
Fully lower the rear door glass. Remove the rear door trim. Remove the plug. Tighten the rear door seal and remove the screw. Loosen the bolt. Pic. 8.23. Components to...

Removal and installation of the block of a forward door
Remove glass of a forward door. Remove the inner handle. Remove the front door speaker. Disconnect the power window motor connector, front door lock actuator connector,...

Removal and installation of the block of a back door
Remove glass of a back door. Remove the inner handle. Remove the rear door speaker. Disconnect the power window motor connector and the door lock actuator auto...

Main characteristics of power windows
Pic. 8.29. Windows car Mazda 6: 1 - driver's side; 2 – the main switch of a window regulator with the servo drive; 3 - except for the driver's side; 4 – the switch of a...

Power window motor with servo
Design and principle of operation The power window motor is equipped with a connector and a gear. Two proximity switches on the Hall sensor are installed in the socket....

Door lock servo system
The control unit and the door lock timer unit are combined, the functions of the door lock servo system are also similar to those of the corresponding system of the...

Removal and installation of a regulator of a window regulator with a servo drive
Disconnect the negative battery cable. Remove the front door/rear door glass. Remove the front door/rear door speaker. Remove the power window motor. Pic. 8.34. Nut of...

Removal and installation of the electric window regulator motor with a servo drive
Disconnect the negative battery cable. Remove the front door trim or rear door trim. Disconnect the power window motor connector. Turn away bolts. Pic. 8.37. Removing...

Disassembly and assembly of the trunk lid
Disconnect the negative battery cable. Remove the trunk lid trim. To remove the outer trunk lid handle and trunk lid lock cylinder, remove the rear trim. Pic. 8.38....

Rear window heater
The electric rear window defroster is designed to remove frost, water condensation and thin ice crust. Pic. 8.53. Rear window heating system: 1 – the relay of a heater...

Sunroof
Attention! Do not allow passengers to get up or stick body parts or objects out of the sunroof while the vehicle is moving. Before closing the sunroof, make sure that...

Removal and installation of a hatch deflector
Open the sunroof glass completely. Remove upholstery. Loosen the screws. Release the hooks. Press in the back of each hook. After moving the hooks back, press them up....

Removal and installation of hatch glass
Close the sunroof glass completely. Fully open the curtain. Pic. 8.58. Glass removal Loosen the screws and remove the sunroof glass (pic. 8.58). Pic. 8.59. Removing the...

Sunroof adjustment
Close the sunroof glass completely. Pic. 8.60. Measuring the gap between the sunroof glass and the body Measure the gap and height between the glass panel and the body...