Electrical equipment of the car engine Mazda 6 (GG)

Electrical equipment of engines — general information
Pic. 2.67. The working components of the electrical equipment of the Mazda 6 car engine: 1 - spark plug; 2 - generator; 3 - high-voltage wire; 4 - ignition coil; 5 -...

Charging system — general information
Pic. 2.68. Generator: 1 - generator; 2 - heat-insulating screen of the generator; 3 - generator air duct As already mentioned, the charging system does not use a voltage...

Ignition coil — general information
Pic. 2.70. Ignition coil: 1 - ignition coil - top view; 2 - secondary conclusions; 3 - ignition coil - side view; 4 - ignition coil; 5 - PCM block The ignition coil has...

Spark plug — general information
An iridium spark plug is used. The central electrode has a diameter of 0.6 mm and is made of an iridium alloy. Pic. 2.71. Spark plug: 1 – iridium alloy; 2 - platinum tip...

Starter — general information
Pic. 2.72. Starter wiring diagram: 1 - ignition switch; 2 - battery; 3 - holding winding; 4 - retracting winding; 5 - electric motor The starter has a coaxial gearbox...

Checking the ignition timing
Note. In normal cases, the ignition timing is not adjustable. To check the setting of the ignition timing, the presence of a specialist and a WDS device or its...

Checking the idle speed
Switch off electrical consumers and warm up the engine. Start the engine. Maintain the engine speed at approximately 3000 min -1 until the cooling fans begin to operate....

Checking the composition of the mixture at idle
Switch off electrical consumers and warm up the engine. Idling (L8 engine) Idling (LF engine, manual transmission model) Idling (LF engine, automatic transmission model)...