Car clutch repair Mazda 6 (GG)

General information about the clutch
The clutch is located between the engine and gearbox and is designed to disconnect and connect the flywheel mounted on the engine crankshaft and the gearbox input shaft....

Bleeding the hydraulic clutch release
Attention! Be careful not to spill clutch fluid on painted surfaces. If this happens, immediately wash off the liquid with water. Note. Do not mix different brands of...

Pedal Height Adjustment
Pic. 3.3. Pedal Height Adjustment Diagram Measure the distance from the pedal pad to the floor covering. Adjust the height of the clutch pedal if necessary. To do this,...

Checking and adjusting the free play of the clutch pedal
Pic. 3.4. Pedal Freeplay Adjustment Diagram Press the clutch pedal until resistance appears. Adjust the clutch pedal free play if necessary. To do this, loosen the...

Checking the clutch release position
Pull the parking brake lever until the wheels lock. Start the engine and let it run at idle. With the clutch pedal not depressed, slowly engage reverse gear. Lock the...

Removal and installation of the clutch pedal
Remove the panel of finishing of a combination of devices. Remove the instrument cluster block. Remove the top of the dashboard. Remove the clutch master cylinder pusher...

Removing and installing clutch hydraulic pipes
Note. Brake and clutch hydraulic fluid share a common reservoir. If the clutch tubes were disconnected during the procedure, top up the clutch fluid (brake fluid), bleed...

Removal and installation of the master cylinder of a drive of deenergizing of coupling
Drain the hydraulic clutch fluid. Remove the master brake cylinder by unscrewing the mounting bolts. Remove the vacuum brake booster by unscrewing the mounting bolts....

Removal, check and installation of coupling
Pic. 3.11. Removing and installing the clutch: 1 – the working cylinder of a drive of deenergizing of coupling; 2 - gearbox; 3 - plug cover; 4 - release bearing; 5 -...