Car steering Mazda 121 (3)

Steering — design description
The steering system consists of a steering wheel, a two-piece steering shaft, a steering mechanism and steering rods. The steering wheel is bolted to the steering shaft...

Precautions when working with an inflatable airbag
Before removing the airbag, disconnect the negative battery cable and lay it aside. When disconnecting the wires from the battery, people should not be near the airbags...

Removal and installation of a steering wheel
Attention: For the Ford KA model, the horn contact is built into the airbag module. If the horn contact fails, the entire airbag assembly must be replaced. It cannot be...

Removal and installation of the hinge of steering draft
Removing Mark the positions of the front wheels so that the balanced wheels can then be returned to their original positions. With the vehicle on the ground, loosen the...

Removal and installation of rubber covers of the steering mechanism
Removing Remove tip (hinge) with tie rod (1). Loosen locknut (2) from the tie rod. Loosen the clamps on the outside (1) and inside (2) with suitable pliers. Remove outer...

Removal of air from the steering mechanism
Air in the hydraulic booster makes it inefficient. Air can get into the system when it is being taken apart for repairs, or leaks can cause the fluid level in the...

Vehicle wheel alignment
Optimum driving performance and minimal tire wear are only achieved when the wheels are fitted correctly. With increased and uneven tire wear, insufficient stability,...